Technical data

Agilent E7501A Getting Started 2-1
2 Performing Acceptance Test Procedures
In this chapter, you will learn about:
• Performing Acceptance Test Procedures
After satisfying the requirements and steps detailed in Chapter 1,
“Installation and Configuration””, the following manual Acceptance Test
Procedure (ATP) may be performed.
Performing an ATP is not required and is provided and intended as a
functionality check only; it is not intended for testing against customer
specifications. This ATP consists of a set of tests that can be performed in
under two hours with a minimum of test equipment.
Acceptance Tests
• “Test 1. CW Frequency and Power” on page 2-2
• “Test 2. AM Accuracy” on page 2-5
• “Test 3. FM Accuracy” on page 2-8
• “Test 4. Pulse Modulation Level Accuracy” on page 2-11
• “Test 5. Verify Hopping with Two Pulse Modulated Signals” on
page 2-14
• “Test 6. Verify Synchronization of the Racal 3153” on page 2-16
Required Test Equipment or Equivalent
• Agilent E7501A arbitrary analog signal developer
• Agilent 8563E spectrum analyzer