Technical data

1-20

Agilent E7501A Getting Started

Installation and Configuration

Step 5. Starting the Agilent E7501A Software

1. Click the Start menu,

point to Programs,

point to Agilent Signal Studio,

point to E7501A Signal Development System,

point to and click E7501A Signal Developer.

2. The Agilent E7501A arbitrary analog signal developer software should

open and be ready for use.

At this point, an Acceptance Test Procedure (ATP) may be performed.

The ATP is a set of manual tests and is documented in the section of

“Performing Acceptance Test Procedures” on page 2-1. The ATP is

intended as a functionality check and is not intended for testing against

customer specifications.