Technical data

1-16 Agilent E7501A Getting Started
Installation and Configuration
Step 4. Configuring Hardware/Software Assets
To Edit the Channel Field Select the Channel field and select the channel from the drop-down
selection box that is to be used with this asset.
CAUTION The following table shows the default channel that is used with each output
of a Racal 3153 waveform generator. When changes are made to the channel
field, the corresponding cabling on the front panels must also be changed.
The default channel settings should not be changed unless you understand
that changing these channels also changes the filters and frequency ranges
used by each of these channels.
To Edit the Filter Field Select the Filter[1,2,3] field and enter the directory path and file name to
designate a particular correction file. This correction file is used to correct
(offset) the response of a built-in filter. (For example, when using the
Racal 3153 waveform generator as the modulation source, a correction file
named
C:\Temp\Filter_AM_1.txt could be created that contains values
to offset the response of the built-in filter for Channel 3.)
Each correction file must contain correction-value pairs in a sequential list.
The list is composed of a frequency point and an offset power value that is to
be applied at each specific frequency point. Unspecified points, between
correction points, are interpolated.
(Optional)
Configuring Other
Available Assets
The process for configuring other available assets follows a similar process
to configuring an RF source and a modulation source.
Agilent Technologies E6432A Racal 3153 Default Channel
Pulse Output 1 1
FM Output 2 2
AM Output 3 3