Installation guide

Agilent 81250 ParBERT Installation Guide, February 2002 95
Troubleshooting the ParBERT Installation
This chapter describes some possible problems you could run when you
are installing ParBERT, and provides some basic tips for correcting
them.
NOTE This chapter provides only tips for troubleshooting the ParBERT
components from Agilent Technologies. If there are problems from the
external equipment, you have to check the user documentation of this
equipment.
You can also check the ParBERT Web site for frequently asked questions
at the following URL:
• http://www.agilent.com/find/parbert/
Problems at the Power-On
Selftest
Depending on the start-up configuration, ParBERT runs a selftest at
power on (see ”How to Select the Start-Up Settings” on page 77 for more
information).
If any conflicts are found during the power-on selftest, ParBERT notifies
you. Depending on the problem found, it is recommended that you run
the complete set of selftests to specifically identify the problem.
You can start the selftests from the System menu in the ParBERT user
software. See the online Help for more information about the available
selftests.