Installation guide

Starting ParBERT for the First Time Starting the ParBERT User Software
86 Agilent 81250 ParBERT Installation Guide, February 2002
To select the system:
1 Click the Change button.
Figure 56 Selecting a System
2 Choose from the list of available systems.
The list includes also demo and offline systems (see ”Build Systems”
on page 81).
Systems already in use by an active user interface cannot be chosen.
3 Confirm.
How to Specify a Start Setting
This section of the Agilent 81250 User Interface Configuration Window
applies only to systems that have already been in use.
The complete setup for a system and a device to be tested including all
parameters as well as references to the data to be sent or expected is
called setting.
This section allows to load one of the stored settings of the chosen
system automatically with the user interface.
That means, you need only start the user software and all systems of the
Agilent 81250 Parallel Bit Error Ratio Tester are ready for testing a
particular device.
Figure 57 Selecting a Setting