Installation guide

Starting the ParBERT User Software Starting ParBERT for the First Time
Agilent 81250 ParBERT Installation Guide, February 2002 85
How to Select the Firmware Server
If you are running the ParBERT user software in local mode, the
firmware server is found on the same PC which is called LOCALHOST.
If you are running the ParBERT user software in remote mode,
LOCALHOST is not available. You have to specify the network node on
which the firmware server is running. This requires that the ParBERT
controller has been connected to the LAN (see ”Connecting ParBERT to
the LAN” on page 91).
The selection is made by clicking the Change button.
Figure 55 Selecting a PC on which the Firmware Server is Running
In this window, you can enter the computer name or the IP address and
the associated port of the ParBERT controller you would like to connect
to.
You can update the list of hosts by clicking Refresh List of running
Servers. Depending on the checkbox, the list shows names or IP
addresses. Note that only hosts running in the same subnet as the
computer running the ParBERT user interface are recognized.
How to Select the System
The basic (default) system is DSRA.
You may wish to operate a different ParBERT system from this user
interface.
If you start the user interface more than once, you have to choose a
different ParBERT system for each user interface.