Installation guide

Software Installation and Update Updating the Firmware (BIOS)
72 Agilent 81250 ParBERT Installation Guide, February 2002
4 Click Yes in the Shut Down window (you still have to keep the Shift
key depressed).
5 When the new Login dialog box is displayed, release the Shift key.
6 In the new Login dialog box, enter “Administrator” as the User name
and “DVTADM” as Password.
NOTE The next time you power on the mainframe, an error message pops up,
stating that the password was not typed correctly. This is because
Windows NT logs on as the last known user, in this case, “DVT”.
All you have to do is close the error prompt, and reenter User Name and
Password.
NOTE All user names and passwords used in this manual are the defaults. It is
recommended to change these passwords.
Updating the Firmware (BIOS)
If you have upgraded from a previous version, the new ParBERT user
software may be incompatible with the firmware version installed in
your modules.
Depending on the start-up settings (see ”How to Select the Start-Up
Settings” on page 77), the user software automatically checks the
firmware of the modules to determine whether a firmware update is
necessary.
If a version conflict is detected, a window pops up letting you know that
a firmware update is highly recommended.
1 Click OK to start the firmware update.