Installation guide

Software Installation and Update Installing/Updating the ParBERT User Software
70 Agilent 81250 ParBERT Installation Guide, February 2002
Installing/Updating the ParBERT
User Software
You should follow this procedure in the following cases:
• You are upgrading from a previous version
• You are setting up an external ParBERT controller
• You wish to use a remote PC for operating ParBERT over the LAN
Prerequisites
For the requirements the PC has to meet see ”Installation Prerequisites”
on page 28.
Installation/Update Procedure
NOTE Microsoft Internet Explorer 4.01 or higher is required for the online help.
The installation procedure checks your system for an appropriate
version and suggests installing Internet Explorer if that is not available.
Please follow the instructions on the screen, reboot the system when it is
requested and log on as administrator again to finalize the installation.
To install or update the user software:
1 Prepare the PC.
If you are updating the user software on the embedded controller, do
the following:
– Power down and switch off the system.
– Connect the separate CD-ROM drive to the appropriate SCSI
connector of the controller.
– Make sure you have selected a free SCSI ID number, ID #3 is
recommended.
– Switch on the CD-ROM drive.
– Switch on the mainframe and wait until the boot is finished.
2 Log on as the administrator, as described under ”Logging on as the
Administrator” on page 71.