Installation guide

Setting Up ParBERT Modifying an Existing ParBERT System
48 Agilent 81250 ParBERT Installation Guide, February 2002
To open a module:
1 Using a T-10 size Torx screwdriver, remove the seven screws from the
side panel of the module. The locations of the screws are shown in
Figure 25.
Figure 25 Cover Screws of ParBERT Modules
2 Set the cover and screws to the side.
How to Add or Exchange a Frontend
This section describes the work necessary to exchange frontends of the
delivered ParBERT modules.
NOTE After adding or exchanging frontends, make sure you finish up according
to the description under ”How to Proceed After Changing the
Hardware” on page 56.
There are two types of frontends for ParBERT: generator frontends and
analyzer frontends. These are shown in the following illustrations.
Figure 26 Generator Frontend of an E4861A Module
3 shorter
screws
4 longer
screws