Installation guide

Modifying an Existing ParBERT System Setting Up ParBERT
Agilent 81250 ParBERT Installation Guide, February 2002 43
Modifying an Existing ParBERT
System
This section provides the information you need if you are changing the
configuration of an existing ParBERT system.
The information is organized as follows:
• ”How to Remove a Module” on page 44
• ”How to Add a Module” on page 44
• ”How to Set the Logical Addresses” on page 45
• ”How to Open a Module” on page 47
• ”How to Add or Exchange a Frontend” on page 48
• ”How to Connect the Trigger Input Pod” on page 54
• ”How to Proceed After Changing the Hardware” on page 56
It is recommended that you keep track of the modules in each mainframe
with a table similar to the one shown below. This table then has to be
updated whenever the ParBERT configuration is changed.
Table 3 Mainframe Configuration Table
Slot Model number Instrument name Logical address Serial number
0
1
2
3
4
5
6
7
8
9
10
11
12