Service manual

90 Chapter 4
Assembly Replacement and Post-Repair Procedures
Replacement of E5035B/37C/37D/38B/40A/41A Modules
Step 4. Type the command shown below. This command will download the firmware to the
module. It takes a few minutes.
Step 5. Type
exit and press [Enter] key to close the Command Prompt application.
Operation Check
Refer to the “Perform System Initialization” on page 28 to verify the system operation.
Module Command (number designates module’s logical address)
E5035B update 5 ..\dsp
[Enter]
E5037C/D update 7 ..\dsp [Enter]
E5038B update 8 ..\dsp [Enter]
E5040A update 10 ..\dsp [Enter]
E5041A update 11 ..\dsp [Enter]