Service manual

Appendix D 179
Error Messages
Error Messages on PC Monitor Display
1. Chapter Title
2. Chapter Title 3. Chapter Title
D. Error Messages
5. Chapter Title
hpe5022_ERROR_NSUP_SENS_CURR_POL The head does not support
the reverse polarity on a
stability measurement. Set
the polarity at normal.
hpe5022_ERROR_OPEN Unable to open some
components in
initialization. (instruments
and the spinstand).
hpe5022_ERROR_OPT_FAIL The optimization is failed.
hpe5022_ERROR_OVERFLOW An overflow is detected in
the parametric module.
Perform the auto
configuration (input range)
or Check if the setting
parameter is correct.
hpe5022_ERROR_PARAMETER_SET_FAILED The acquisition parameters
are invalid for an
oscilloscope. Reduce the
value of the over sampling
rate, the wave averaging
factor or the channel bit
rate.
hpe5022_ERROR_PEAK_NOT_FOUND The peak can’t be found in
the track profile result.
Check if the track profile is
performed properly.
hpe5022_ERROR_PES_DATA Effective position error
signal data can not be
measured.
hpe5022_ERROR_PLL_UNLOCK The PLL is unlocked.
Check if the parameter
setting is correct.
hpe5022_ERROR_QUEUE_OVERFLOW Error queue overflows.
hpe5022_ERROR_RESAMP_FAILED The waveform resampling
has failed.
hpe5022_ERROR_REVISION The revision between
system software and
module firmware in not
same. Reinstall E5023A
software.
Error Messages on PC Monitor Display
Error Code Description