Service manual

174 Appendix D
Error Messages
Error Messages on PC Monitor Display
Error Messages on PC Monitor Display
Table shows the error messages that could appear on the PC monitor display when you use
a demo program or other programs created by the user.
Error Messages on PC Monitor Display
Error Code Description
hpe5022_ERROR_AUTO_CONFIG_FAILED The auto configuration has
failed. Check if the
parameter and head is
correct.
hpe5022_ERROR_AUTO_RANGE_FAIL The auto range has failed.
Check if the parameter and
head is correct.
hpe5022_ERROR_CAL_DATA_CORRUPT Calibration data stored in
the system or head amplifier
board was corrupt. Need to
perform the calibration
again.
hpe5022_ERROR_CAL_FAILED Calibration is failed. Check
the configuration and
cabling, then re-try the
calibration.
hpe5022_ERROR_CLOSE Unable to close some
components (instruments
and the spinstand).
hpe5022_ERROR_CONFLICT_PREC_PATTERN The precompensation
pattern has conflict.
hpe5022_ERROR_D50_NOT_FOUND Can’t find the D50
parameter point. Check the
result of the roll off
measurement.
hpe5022_ERROR_DATA_CORRUPT The measurement data is
corrupt. Check if your
measurement sequence is
correct.
hpe5022_ERROR_EXCESS_TRACK_DATA The data overflows a track
at one revolution. Change
the setting of the user data
rate, rpm, track number,
track format or sector
format.