Service manual

168 Appendix C

Software Tools

Usage of I/O Config

Purpose of I/O Config

I/O Config is to detect the interface devices and configure them. The I/O config is set at

proper setting at factory shipment. However, somehow it might be change. In case of

communication trouble, confirming I/O configure is required.

Procedure of I/O Config

The procedure for I/O Config is as follows.

Step 1. Select

Start - Programs - Agilent I_O Libraries - I_O Config, or click the right mouse

button on the HP logo in the task bar and select

Run I_O Config.

Step 2. Confirm if the “ASRL1”, “GPIB0” and “VXI0” as VISA name is listed in the Configured

Interfaces as shown in Figure C-5 on page 168

Figure C-5 I/O Config Menu

Step 3. If not correct, follows as below.

• If no “VXI0”, select “Agilent E8491” in the Available Interface Types and click on

“Configure” button.

• If no “ASRL1”, select “RS232” in the Available Interface Types and click on

“Configure” button.

• If no “hpib7”, select “Agilent 82350 GPIB” in the Available Interface Types and click

on “Configure” button.