Service manual

Chapter 4 119
Assembly Replacement and Post-Repair Procedures
Cable Connection
1. Chapter Title
2. Chapter Title 3. Chapter Title
4. Assembly Replacement
5. Chapter Title
and Post-Repair Procedures
Connecting the E5039C Bit Error Test Module (Optional)
NOTE This procedure is needed only if the system is configured with the Agilent E5039C Bit
Error Test Module.
Figure 4-14 Cable Connection of the Agilent E5039C (Option)
Table 4-8 Cable Connection (E5039C)
No. Description Connection Part Number
9 SMA(m)-SMA(m) Cable E5039C “Data Out Pos” E5043A/C “Input 2 Data+” E5039-61606
10 SMA(m)-SMA(m) Cable E5039C “Data Out Neg” E5043A/C “Input 2 Data−” E5039-61607
25 SMA(m)-SMA(m) Cable E5039C “Signal In” E5036A “Thru Out 2” E5039-61608