Service manual

118 Chapter 4
Assembly Replacement and Post-Repair Procedures
Cable Connection
Connecting the E5039B Bit Error Test Module (Optional)
NOTE This procedure is needed only if the system is configured with the Agilent E5039B Bit
Error Test Module.
Figure 4-13 Cable Connection of the Agilent E5039B (Option)
Table 4-7 Cable Connection (E5039B)
No. Description Connection Part Number
9 SMA(m)-SMA(m) Cable E5039B “Data Out Pos” E5043A/C “Input 2 Data+” E5039-61606
10 SMA(m)-SMA(m) Cable E5039B “Data Out Neg” E5043A/C “Input 2 Data−” E5039-61607
24 BNC(m)-BNC(m) Cable E5035B “WG IN” E5039B “WG OUT” E5039-61609
25 SMA(m)-SMA(m) Cable E5039B “Signal In” E5036A “Thru Out 2” E5039-61608