Service manual

114 Chapter 4
Assembly Replacement and Post-Repair Procedures
Cable Connection
Connecting the VXI Modules
Figure 4-9 E8491B/E5035B Cable Connection
*1 Already connected inside of the spinstand to the piezo control unit and the piezo power
supply.
NOTE Any IEEE-1394 port can be used on both E8491B and PC.
Table 4-3 E8491B/E5035B Cable Connection
No. Description Connection Part Number
15 MDR-MDR Cable E5035B “Head Amp Ctrl” E5043A/C “Head Amp Ctrl” E5023-61605
21 BNC(m)-BNC(m) Cable E5035B “Trig Out 1” Oscilloscope Ch3 E5023-61613
24 BNC(m)-BNC(m) Cable E5035B “WG IN” E5039B “WG OUT” E5039-61609
26 IEEE-1394 Cable IEEE-1394 Port on PCI Board E8491B “Port A” 8192-8688
29 BNC(m)-DSUB(f) Cable E5035B “Index In” Spinstand Controller “J19” E5023-61609
30 SMA(m)-BNC(m) Cable E5035B “Piezo Ctrl” Spinstand “Analog Input” E5013-61601