Service manual

Chapter 4 105
Assembly Replacement and Post-Repair Procedures
GPIB Card and/or IEEE-1394 Card Replacement
1. Chapter Title
2. Chapter Title 3. Chapter Title
4. Assembly Replacement
5. Chapter Title
and Post-Repair Procedures
GPIB Card and/or IEEE-1394 Card Replacement
Tools Required
• Pozidriv screwdriver
Removal
Step 1. Remove all cables (GPIB cable, IEEE-1394 cable, and serial cable) from the PC.
Step 2. Remove GPIB card and/or IEEE-1394 card from the PC.
Replacement
Step 1. Install a GPIB card and/or an IEEE-1394 card into slot(s) of the PC.
NOTE Before physically installing GPIB card or IEEE-1394 card, you must complete the Agilent
I/O Library installation into the PC.
Generally, you can install a PCI card into any slot in the PC. However, the card position
might cause the problem in case of combination of GP-IB and IEEE-1394 cards.
From the rear view, the IEEE-1394 card must be installed in the most upper (or left) slot
and the GP-IB card must be installed in the second slot from the top (or left).
There is a cable on the IEEE-1394 PCI card to supply power from the connector on the
FDD or the CD-ROM drives. The cable has 4-pin-female connector on one side and has a
4-pin-female and another 4-small-pin-female connectors on the other side in order to split
the power. The 4-small-pin-female is connect with IEEE-1394 card. When you replace the
IEEE-1394 card, you have to remove the cable from the defective PC, too. Then install
them into a new PC.
Step 2. Connect GPIB cable, IEEE 1394 cable, and serial cable to the PC. See “PC (System
Controller) Replacement” on page 104 for how to connect those cables.