Service manual

Chapter 4 101
Assembly Replacement and Post-Repair Procedures
Replacement of Oscilloscope (Agilent 54845A/B) or Spectrum Analyzer
(Agilent E4402B)
1. Chapter Title
2. Chapter Title 3. Chapter Title
4. Assembly Replacement
5. Chapter Title
and Post-Repair Procedures
Replacement of Oscilloscope (Agilent 54845A/B) or
Spectrum Analyzer (Agilent E4402B)
This part describes how to replace the optional oscilloscope/spectrum analyzer.
Removal
To uninstall the oscilloscope/spectrum analyzer from the system, follow below steps.
Step 1. Shut whole system down.
Step 2. Remove all the cables connected to the oscilloscope/spectrum analyzer.
Step 3. Remove the oscilloscope/spectrum analyzer from the system.
Installation
To install the oscilloscope/spectrum analyzer into the system, follow below steps.
Step 1. Install the oscilloscope/spectrum analyzer into the system.
Step 2. Connect the cables to the oscilloscope/spectrum analyzer. Refer to “Cable Connection” in
this chapter.
Operation Check
Refer to the “Perform System Initialization” on page 28 to verify the system operation.