Service manual

Rack Mounting and Option Installation 25Chapter 2
Rack Mounting the
HP E840xA using
Support Rails
This section contains instructions for mounting the HP E840xA mainframe
in an EIA cabinet using the HP E3664A support rail kit. The E3664A kit can
be used with any of the rack mount adapter options; however, the E3664A
is only compatible with HP cabinets. The following procedures apply to all
adapters, with adapter-specific information noted where necessary.
Note If you ordered Cable Tray Option 914, refer to page 34 and install the tray
before rack mounting the mainframe.
Procedure 1. Attach the handles to the adapters using the m5x10 flat head screws
(Figure 2-1). Handles are included only with the HP E840xA
Standard adapters (Option 923).
Figure 2-1. Attaching Handles to the Adapters (Option 923 - kit p/n E8400-80923).
m5x10 Flat Head Screws