Service manual

Rack Mounting and Option Installation 41Chapter 2

Agilent E840xA Air Filter Kit

An optional air filter kit can be purchased for the Agilent E840xA

mainframe. Figure 2-15 shows how to install the kit.

1. Remove the four screws from the rear panel as shown in Figure 2-15.

2. Install the bottom Air Filter Bracket as shown. Use the two pan-head

screws included with the Air Filter Kit.

3. Install the Air filter. Carefully place the filter into the bottom bracket.

4. Attach the top bracket to the mainframe. Hand-tighten the

thumbscrews; do not over-tighten.

Figure 2-15. Installing the Optional Air Filter Kit

1 2

Remove and Discard

4 Screws

Supplied Pan

Head Screws

Insert Filter Into

Bottom Bracket

Place Top Bracket

Over the Filter and

Secure Thumb-Screws

3 4