Service manual

Rack Mounting and Option Installation 31Chapter 2
6. Attach the stationary section to the rack’s front inside rail through the
channel nuts. Use two m5x12 flat head screws. Attach the stationary
section to the rear inside rail using two m5x12 pan-head screws
(Figure 2-9).
Figure 2-8. Removing the Rack Slide Chassis Section from the Intermediate Section
Depress From Back
Side To Remove
Rack FrontRack Rear
Stationary Section Stationary Section Chassis Section
(Right Rack Slide Shown)
Figure 2-9. Installing the Rack Slide Stationary Sections
Mounting Holes When Using
the VXI Plug&Play Compliant Adapters
(Left Rack Slide Shown)
m5x12 Pan Head Screws
(Standard Adapter Kit)
m5x12 flat head screws
(Standard Adapter Kit)
Rack Front Rack Rear