Technical data

2 User’s and Service Guide Supplement
General Overview E8362B, E8363B and E8384B Option H85
Introduction
Introduction
This document describes the differences between the Agilent E8362B, E8363B and
E8364B with Option H85 and the standard E8362B, E8363B and E8364B PNA Series
Network Analyzer.
Information can be viewed or printed regarding the PNA Series Network Analyzer
Data sheets, white papers, or manuals by visiting our web site at
http://www.agilent.com/find/pna.
Description
The Agilent E8362B, E8363B and E8364B Option H85 is a modified version of the
standard E8362B, E8363B and E8364B PNA Series Network Analyzer. Option H85 is
designed to permit insertion of high power amplifiers and other signal conditioning
equipment to allow high power network measurements at RF levels up to 20 Watts
(+43 dBm) from 10 MHz to 40 GHz and 10 Watts (+40 dBm) from 40 GHz to 50 GHz. Refer
to Figure 3, Figure 4, and Figure 5 depending on the type of high power configuration. The
Option H85 is similar to the Option UNL with one exception; the modification supplies
source attenuators without bias tees.
NOTE The Bias Tee's are removed from the Option H85 to allow high power
operation. Specifications for the Agilent E8362B, E8363B and E8364B Option
H85, when configured in Bypass Configuration, are the same as those of an
E8362B, E8363B and E8364B PNA Series Network Analyzer with Options
014, 016, 080, 081 and UNL.
The instrument is shipped from the factory with jumper cables installed on the front panel
in what is referred to as the “Bypass Configuration.” Refer to Figure 2 on page 7. This
configuration will allow the instrument to operate as a standard E8362B, E8363B and
E8364B PNA Series Network Analyzer with Options 014, 016, 080, 081 and UNL.
Additional options are available for the Agilent E8362B, E8363B and E8364B Option H85.
The Agilent E8362B, E8363B and E8364B Option H85 bundles Options 014, 016, 080 and
081 and are part of the H85.