Specifications

11
Features
Frequency Range: 10 MHz to 110 GHz
Dynamic Range > 110 dB, without the need for external RF and LO sources
Built-in Kelvin bias tee on combiners which brings the bias signal close to the
device being measured
Industry leading stability, less the 1% drift over a 24 hour period
Mechanical attenuation of 25 to 30 dB available for above 67 GHz on either port
1 or 2 for high power device measurements
Removing the combiners converts the system to extend W-band waveguide
system for the measurements from 67 GHz to 110 GHz
Modules fully supported by Cascade® probe stations and Agilent accessories
to easily connect to probes
Utilizes Agilent’s patented weight least squares calibration method in 1.0 mm
for industry leading accuracy
Provides two and four port S-parameter measurements from 10 MHz to
110 GHz in a single sweep
Full power control over the entire frequency range down to as low as 50 dBm
Receiver leveling to maintain accurate power across the entire frequency range
Broad power sweeps across the entire frequency range
Supports true differential measurements across the frequency range
Supports scalar mixer measurements
Integrated pulse measurement capability
www.agilent.com/find/mmwave
Network Analyzer Overview 110 GHz
Millimeter-wave network analyzers
PNA-X millimeter wave
network analyzers
This configuration of the millimeter-wave
network analyzer is based on the N5247A
PNA-X network analyzer. It allows both a
single sweep measurement solution that
starts at 10 MHz, up to 110 GHz. This
solution is a direct replacement for the
8510XF with improved performance. In
particular, an added capability to control
and use receiver leveling allows you to set
the power accurately at the 1.0 mm test
port. Architecturally very similar to the
existing N5250C system but is configurable
as separate components that include the
N5247A PNA-X, either a 2 or 4 port test set
controller, and the appropriate frequency
extenders as needed.
N5247A PNA-X Based Single Sweep
Solution (10 MHz to 110 GHz)