Specifications

From your PNA Series Network Analyzer:
4) Next, map your PC’s CD drive to the network
analyzer. Launch Windows
®
Explorer to begin
this procedure.
5) On the main menu bar, click Tools. From the
menu, click Map Network Drive. The network
analyzer will choose the next available drive letter.
It is also possible to assign other available drives.
Record this drive letter:_______________.
6) From the Map Network Drive window, click the
Folder box. Type (or select if available) the path
(\\computername\sharename). You learned the
computer name in step 2 and the share name in
step 3. NOTE: If you are logged onto the analyzer
using the same logon as your PC, it is not necessary
to enter “Connect Using a Different User Name”.
However, if you prefer to connect under a different
user name, click the hyperlink “different user
name” and type the user name and password. If the
user name is in a different domain, use the format:
domain\username.
7) To connect to the shared drive automatically each
time you log on, check Reconnect at Logon.
8) Click Finish to close the Map Network Drive
window.
9) The PC’s CD drive will now be visible on the
network analyzer’s Windows Explorer as the
drive letter you used in step 5.
10) A window will popup with the contents of the
CD drive on the PC.
11) Proceed to the Software Installation Section 3.3.
3.2 Set-up for software installation from
external USB CD Drive
This procedure has been verified for the HP CDR-Writer
Plus 8200 series CD drive. The following procedure has
not been verified with other USB CD drives.
From your PNA Series Network Analyzer:
1) Exit all applications, including the network
analyzer application.
2) Plug your CD drive’s USB cable into a USB
port located on the network analyzer.
3) Turn on your external CD drive.
4) Wait until Windows recognizes the CD drive.
The Add/Remove Hardware Wizard will
automatically launch.
5) Follow the steps to install the drivers for your CD
drive.
6) You may have to re-start the network analyzer to
finish the installment of the drivers, which will
allow read/write permission from/to the external
CD drive. Proceed to the Software Installation
Section 3.3.
3.3 Software installation
This procedure is general, and has been verified on
Microsoft Visual Basic 6.0, Visual C++ 6.0, and Office
2000, National Instruments
™
LabVIEW, and Agilent VEE
6.0. If you have mapped your PC’s CD drive, perform the
following procedure from your PC. If you have an exter-
nal USB CD drive set up, perform the following proce-
dure from your network analyzer.
1) Insert the software CD into your CD drive.
2) If installation does not immediately start, double
click My Computer. Then, double click the CD.
Run the setup application as outlined in the
software’s documentation. Select the network
analyzer’s drive as the destination for the files to be
installed.
6