User manual

lpErrorDoc.txt
messages may clarify why this error was reported.
700 State Save Recall Error; Failed to save the instrument state. {name}
The instrument could not save an instrument state. Previous error
messages may clarify why this error was reported.
700 State Save Recall Error; Recall data from different FW revision. No
instrument state change. {name}
An attempt was made to recall a state that was saved with an
incompatible version of the instrument firmware. This typically
occurs when a state file is copied from an instrument with a newer
version of firmware to an instrument with an older version of
firmware. Newer versions of instrument firmware can read older
state files. TODO: Parameter is filename.
700 State Save Recall Error; Recall non-saved state register. Recall
ignored.
A recall was attempted for a state register that is unused. If
state file exists, delete explicitly using catalog.
700 State Save Recall Error; Recalled state has a bad checksum. No
instrument state change. {name}
The state file was corrupt or out-of-date, so the recall was
ignored. If state file exists, delete explicitly using the memory
catalog.
700 State Save Recall Error; Save state ignored as the save recall
registers could not be written.
The instrument could not save an instrument state because it could
not write out the information of which save/recall registers are in
use. Previous error messages may clarify why this error was
reported.
700 State Save Recall Error; Unable to delete saved state. No instrument
state change.
Could not delete a saved state. Previous error messages may clarify
why this error was reported.
700 State Save Recall Error; Unable to read the secondary frame instrument
state file. The secondary frame has been turned off.
The format that is currently active needed the secondary frame
instrument state file to generate the secondary frame in pattern
RAM, but the instrument state file was either not previously saved
or it was deleted. You must create and save a secondary frame
instrument state.
702 Load/Store Error; Cannot create a filter with no coefficients.
A filter must have at least one coefficient specified.
702 Load/Store Error; Cannot create a Modulation with less than one bit per
symbol.
A modulation must have at least two states specified.
702 Load/Store Error; Cannot create a shape with less than 2 points.
Page 63