User manual

lpErrorDoc.txt
7.7.2.4.1).
-123 Exponent too large
The magnitude of an exponent was greater than 32000 (see IEEE
488.2, 7.7.2.4.1).
-121 Invalid character in number
An invalid character for the data type being parsed was
encountered. For example, an alpha in a decimal numeric or
a “9” in octal data.
-120 Numeric data error
An error was encountered when parsing a data element that appears
to be numeric including non-decimal numeric types.
Specific details are not available.
-114 Header suffix out of range
The value of a header suffix attached to a program mnemonic
makes the header invalid.
-113 Undefined header
The header is syntactically correct, but it is undefined for
this specific device. For example, *XYZ is not defined for
any device.
-112 Program mnemonic too long
The header contains more than twelve characters (see IEEE
488.2, 7.6.1.4.1).
-111 Header separator error
A character that is not a legal header separator was encountered
while parsing the header.
-110 Command header error
An error was detected in the header. This message is used when
the device cannot detect the more specific errors described for
errors -111 through -119.
-109 Missing parameter
Fewer parameters were received than required for the header.
For example, the *ESE common command requires one parameter,
so receiving *ESE is not allowed.
-108 Parameter not allowed
More parameters were received than expected for the header. For
example, the *ESE common command only accepts one parameter, so
receiving *ESE 0,1 is not allowed.
-105 GET not allowed
A Group Execute Trigger was received within a program message
(see IEEE 488.2, 7.7). Correct the GPIB controller program so
that the GET does not occur within a line of GPIB program code.
Page 45