User manual

lpErrorDoc.txt
The data rate is not contained in the defined data rate table.
-220 Parameter error; Spread factor exceeds maximum allowable spread factor
The spread factor exceeds the maximum allowable spread factor. The
maximum allowable spread factor is currently 256.
-220 Parameter error; Spread factor not valid
The spread factor should be a power of 2 that is between 4 and 256.
-220 Parameter error; {name} The modulation type has been defaulted.
The specified file is not a modulation file type so the modulation
type has been defaulted.
-215 Arm deadlock
The arm source for the initiation of a measurement is set to
GET and a subsequent measurement query is received. The
measurement cannot begin until a GET is received, but the
GET would cause an INTERRUPTED error.
-214 Trigger deadlock
A trigger source for the initiation of a measurement is set to GET
and a subsequent measurement query is received. The measurement
cannot begin until a GET is received, but the GET would cause an
INTERRUPTED error.
-213 Init ignored
A request for a measurement initiation was ignored as another
measurement was already in progress.
-213 Init ignored; Cannot initiate sweep in manual mode.
The manual mode is on and therefore the instrument cannot sweep.
-213 Init ignored; Sweep is already continuously initiated.
The list/sweep is continuously initiated and sweeping, therefore
the command is not legal according to SCPI.
-213 Init ignored; Sweep is already initiated.
The list/sweep is currently initiated and sweeping, therefore the
command is not legal according to SCPI.
-213 Init ignored; Sweep is off.
A list sweep was requested but list sweep is currently off.
-213 Init ignored; Unable to sweep due to sweep being in an error state.
The sweep error should be fixed.
The number of list, power, and/or dwell points are in conflict, or
a serious system error has occurred in list/sweep. A previous error
report should have described the error that is stalling list/sweep.
-212 Arm ignored
Page 41