User manual

lpErrorDoc.txt
increased. To avoid the error, increase the symbol rate of physical
channel or decrease the number of bits of TrCHs.
-221 Settings conflict; Unsupported configuration for Pilot Gating. Pilot
Gating can only be used for the Pilot alone or in conjunction with
REACH or RCCCH.
Changing the R-PICH gating from full is only allowed in three
channel structures: R-PICH, R-PICH with the R-CCCH or R-PICH with
the R-EACH.
-221 Settings conflict; Uplink and Downlink setting conflict. All selected
Uplink timeslots are now set to Downlink.
An Uplink timeslot type has been selected while another timeslot(s)
has Downlink selected. In NADC and PDC digital modulation for
bursted data, only either Uplink (base to mobile) or Downlink
(mobile to base) Traffic Channel type can be selected for all
timeslots at any one moment. To continue data transmission, all
Uplink timeslots have been changed to the Downlink configuration.
-221 Settings conflict; User FSK file has deviations which are incompatible
with the current symbol rate. The modulation type has been defaulted.
A frequency in the selected user FSK file exceeds the maximum
possible deviation for the current symbol rate. The default
modulation type for the mode has been selected to resolve the
conflict.
-221 Settings conflict; User Power Correction is only available during Ext
Detector Leveling Mode.
User Power Correction is only applied when the Leveling Mode is
using an External Detector. Enable Ext Detector Leveling Mode first
before attempting to use User Power Correction.
-221 Settings conflict; Walsh conflict between: {name} and {name}
There is a Walsh collision between two channels specified. Either
one Walsh code is equal to the other, or it falls under the other
Walsh's tree. A Walsh collision results in an invalid signal.
Select a different Walsh code according to Walsh selection rule.
-221 Settings conflict; Walsh length invalid! Changed to default Walsh
number
The current Walsh length is invalid for the current data rate. For
data rate 2X and above, doubling the rate will half the walsh
space. The channel Walsh number has been changed to the highest
valid Walsh code.
-221 Settings conflict; When combined GSM/EDGE is enabled, the maximum
number of filter symbols allowed is 32 (Skew Mode off) or 16 (Skew
Mode on). The filter type has been defaulted.
*** No documentation ***
-221 Settings conflict; When in combined EDGE/GSM mode, the EDGE modulation
type must be 1 bit per symbol or 3 bits per symbol, otherwise the
modulation type is defaulted back to EDGE modulation.
When in combined EDGE/GSM mode, the EDGE modulation type must be 1
bit per symbol or 3 bits per symbol, otherwise the modulation type
Page 39