User manual

lpErrorDoc.txt
firmware release is not available, then an alternate solution is to
load a compatible FPGA image by pressing the Update SSIO Interface
FPGA soft key located under the Diagnostics menu. DO NOT INTERRUPT
the update once it has started. You must cycle power on the N5102A
when the update is completed.
The Signal Generator is not compatible with the newer version of
the N5102A SSIO FPGA. Obtain an update of the ESG firmware or load
a compatible image of the SSIO FPGA using the update soft key under
the Diagnostics menu.
-221 Settings conflict; Skew cannot be enabled until the skew adjustment
has been completed.
Skew cannot be enabled until the skew adjustment has been
completed.
-221 Settings conflict; Skew cannot be enabled when filters are active that
exceed a length of 32 symbols.
Skew cannot be enabled when filters are active that exceed a length
of 32 symbols.
-221 Settings conflict; Skew is not compatible with the existing modulation
type. Skew has been disabled.
Skew is not compatible with the existing modulation type. Skew has
been disabled.
-221 Settings conflict; Skew limits depend on the rate of the active
format. The skew has been limited to the current upper or lower bound
as appropriate.
Skew limits depend on the rate of the active format. The skew has
been limited to the current upper or lower bound as appropriate.
-221 Settings conflict; Slot Format #1 does not allow CM by Puncturing.
Slot Format #1 does not allow CM by Puncturing.
-221 Settings conflict; Slot Format #16 does not allow CM by SF/2.
Slot Format #16 does not allow CM by SF/2.
-221 Settings conflict; The state of AWGN's Ec Reference has been turned
off. Ec/No information is no longer valid. Please choose a valid EcRef
channel type.
EcRef must be selected as a channel in the 'on' state. Therefore
since the state of the channel is now 'off', Ec/No values displayed
will be invalid.
-221 Settings conflict; Sum of FM1/PM1 and FM2/PM2 deviation cannot exceed
maximum value.
The sum of FM1/PM1 and FM2/PM2 deviation must always be less than
or equal to the maximum deviation value.
-221 Settings conflict; TCH/FS Conflicts with another multiframe type.
*** No documentation ***
-221 Settings conflict; TGD parameter is not set to Undefined or 0. TGPL1 *
Page 37