User manual

lpErrorDoc.txt
channel, you must change to the proper radio configuration before
continuing.
-221 Settings conflict; RSCH is only defined for Radio Configuration 1 and
2. You must set one of these Radio Configurations before configuring
or using this code channel.
The command attempted to enter a value or setting for the R-SCH in
RC1 or RC2. If this is the correct R-SCH, change to the desired
radio configuration and resend the command. If not, select the
command for the desired R-SCH. Use the following list to determine
the correct R-SCH command to use: R-SCH: Used in RC1 and RC2
R-SCH1: Used in RC3 and RC4 for Channel 4 R-SCH2: Used in RC3 and
RC4 for Channel 2
-221 Settings conflict; RSCH with Turbo coding is only available in Radio
Configurations 3 and 4. You must set one of these Radio Configurations
to proceed
Turbo coding is only allowed in R-SCH in RC3 and RC4. If turbo
coding is needed, change to the appropriate radio configuration,
set up the proper channels in addition to the R-SCH and turn on
turbo coding.
-221 Settings conflict; RSCH1 is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
The command attempted to enter a value or setting for the R-SCH1 in
RC3 or RC4. If this is the correct R-SCH, change to the desired
radio configuration and resend the command. If not, select the
command for the desired R-SCH. Use the following list to determine
the correct R-SCH command to use: R-SCH: Used in RC1 and RC2
R-SCH1: Used in RC3 and RC4 for Channel 4 R-SCH2: Used in RC3 and
RC4 for Channel 2
-221 Settings conflict; RSCH2 is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
*** No documentation ***
-221 Settings conflict; Selected digital modulation cannot be on with pulse
modulation.
There is a hardware conflict between the selected digital
modulation and pulse modulation. The most recently requested
modulation will be turned on. The previous modulation will be
turned off.
-221 Settings conflict; The selected Eb Ref channel which 3GPP Uplink AWGN
refers to must be on.
The physical channel to which the AWGN Eb Ref refers is off. Turn
the channel on.
-221 Settings conflict; Sequence list not specified
A list sweep was attempted but there was no list specified.
-221 Settings conflict; The Signal Generator firmware is not compatible
with the newer version of the N5102A SSIO FPGA. Check for newer
firmware at http://www.agilent.com/find/upgradeassistant. If a newer
Page 36