User manual

lpErrorDoc.txt
An attempt was made to setup the R-DCCH while in a radio
configuration that does not support this channel. This channel is
only available in RC3 and RC4. If the R-DCCH is the desired
channel, you must change to the proper radio configuration before
continuing.
-221 Settings conflict; REACH is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
An attempt was made to setup the R-EACH while in a radio
configuration that does not support this channel. This channel is
only available in RC3 and RC4. If the R-EACH is the desired
channel, you must change to the proper radio configuration before
continuing.
-221 Settings conflict; Real-time noise in ARB formats cannot be combined
with a baseband frequency offset. The noise has been turned off.
Real-time noise in ARB formats cannot be combined with a baseband
frequency offset. The noise has been turned off.
-221 Settings conflict; Real-time noise in ARB formats cannot be used above
100Msps/bandwidth_factor. The noise has been turned off.
Real-time noise in ARB formats cannot be used above
100Msps/bandwidth_factor. The noise has been turned off.
-221 Settings conflict; Real-time noise in ARB formats cannot be used when
the RMS value of the waveform is unknown. Please see any previous
error message for why the RMS could not be calculated. The noise has
been turned off.
Real-time noise in ARB formats cannot be used when the RMS value of
the waveform is unknown. Please see any previous error message for
why the RMS could not be calculated. The noise has been turned off.
-221 Settings conflict; Reference marker not set for marker delta
measurements
No reference marker was set in the analog sweep marker table
editor. A reference marker must be set before marker delta
measurements can be performed.
-221 Settings conflict; The requested operation is not allowed in a two box
{name} setup.
Certain operations, such as setting to equal powers, are not
allowed in a two-ESG setup. A two-ESG setup exists when either
Voltage Other ESG or Percent Power Other ESG are greater than 0.0.
-221 Settings conflict; RF Power Off during power search.
While executing power search, the RF Power must be ON. Please press
RF On/Off to turn RF Power On and repeat power search.
-221 Settings conflict; RPICH is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
An attempt was made to setup the R-PICH while in a radio
configuration that does not support this channel. This channel is
only available in RC3 and RC4. If the R-PICH is the desired
Page 35