User manual

lpErrorDoc.txt
data source is external.
Single is not a valid repeat setting for an external data source.
-221 Settings conflict; PHS or TETRA scramble cannot be on when the
currently selected modulation type has more than 2 bits per symbol.
The baseband generator provides modulations with more than 2
bits/symbol. For these modulations, PHS and TETRA scramble are
disabled.
-221 Settings conflict; Power list and dwell list are of unequal size. Set
one list equal to size one or make their sizes equal.
Both the dwell list and the power list have more than one element,
and they are not of equal size. If any frequency, power, or dwell
lists have more than one element, they must all have the same
number of elements. A list of a single element is the same as a
list of equal size with the single element repeated the necessary
number of times.
-221 Settings conflict; Power Search with Optimize Noise mode ON not
allowed.
While in Low Phase Noise mode, executing power search is not
allowed.Under the Frequency key (More 3 of 3), please select
Optimize Noise below 500 MHz off, and repeat power search.
-221 Settings conflict; Pulse period min setting adjusted for Freqs less
than and equal to 3.2 GHz.
There is a hardware conflict between the internal pulse modulation
and Freq settings. For Freqs less than or equal to 3.2 GHz the
period setting is limited to 200 nsec.
-221 Settings conflict; Pulse period set less than pulse width value. Pulse
width changed to match period value.
A pulse period has been entered that is smaller than the pulse
width. The instrument automatically adjusts the pulse period to
match the pulse width.
-221 Settings conflict; The puncture rate is > 60 on {name} channel
{value}, increase the {name} Slot Format or edit the {name} fields to
reduce the puncture percent.
The puncture rate of each TrCH should be smaller than 60%, which is
displayed on UI screen as "Max Puncture" value. Max Puncture is
calculated as (1 - Puncturing Limit) * 100. Puncturing Limit is
defined at 3GPP STD TS 125 331. To avoid the error, increase the
symbol rate of physical channel, decrease the number of bits of the
TrCH, or align the rate matching attribute of each TrCHs.
-221 Settings conflict; The puncture rate is >= {value} percent on DCH Ch
{value}, increase the DPCH Slot Format or edit DCH fields to reduce
the puncture rate. All DPCH channels were turned off.
Transport channels cannot be punctured more than X%. The slot
format needs to be increased (which in turn increases the symbol
rate) on the underlying DPCH channel, or the transport channel
parameters must be changed to reduce the puncture percentage. The
underlying DPCH channel has been turned off.
Page 33