User manual

lpErrorDoc.txt
-221 Settings conflict; IR buffer size is too small.
The 3GPP standard defines the transport block set size as 0 to
200000
-221 Settings conflict; The maximum value of the Summing Ratio is dependent
on the Modulator Atten value. Summing ratio value has been modified to
reflect the decreased IQ Modulator Atten value.
The maximum value of the Summing Ratio has a dependency on the
Modulator Atten value. Summing Ratio Max Value = +50dB +Modulator
Atten Summing Ratio Min Value = -50dB -Modulator Atten
-221 Settings conflict; Missing parameters: When state is on, all DwPTS
parameters are required.
Missing parameter. When the state is on, Downlink Pilot requires
all following fields: power in db, SYNC code, and rotation pattern.
-221 Settings conflict; Missing parameters: When state is on, all UpPTS
parameters are required.
Missing parameter. When the state is on, Uplink Pilot requires all
following fields: power in db, SYNC code, and time offset.
-221 Settings conflict; The N5102A SSIO FPGA is not compatible with the
Signal Generator firmware. Press the Update SSIO Interface FPGA soft
key located under the Diagnostics menu. DO NOT INTERRUPT the update
once it has started. You must cycle power on the N5102A when the
update is completed.
The Signal Generator does recognize the version number associated
with the N5102A SSIO FPGA. The FPGA must be updated to support this
feature.
-221 Settings conflict; New hardware settings can no longer support the
last IQ Out selection. IQ Out defaulted to Source 1.
Based on new settings in the vector modulation system, a previous
setting related to the IQ Output (rear panel) is no longer valid.
The setting will be default to the input selected for Source 1.
-221 Settings conflict; New wave shape changes limit for internal
frequency: frequency changed to new limit.
When using the internal modulation source, the upper limit varies
for the different waveforms. If the user changes the waveform when
the internal source frequency is higher than that allowed for the
new waveform, the frequency for the source will be changed, and the
user informed of that change with this message.
-221 Settings conflict; Nfirst1 - Nlast1 <= 6
GAP1 is a single frame method gap that is greater than 7 slots
long. DTX slots per frame should be less than 8.
-221 Settings conflict; Nfirst1 >= 8 or Nlast1 <= 6 or When TGD is not set
to Undefined or 0, Nfirst_1 + TGD >= 30
GAP1 is a double frame method gap; the DTX slots per frame is > 7.
DTX slots per frame should be less than 8.
-221 Settings conflict; Nfirst2 - Nlast2 <= 6
Page 31