User manual

lpErrorDoc.txt
-221 Settings conflict; In fixed position the block size must be either 0
or equal to block set size. The block size has been set to the block
set size.
In fixed position mode the block size must be equal to either the
block set size or 0.
-221 Settings conflict; In the F-PDCCH overlaid mode, the relative power of
the F-PDCCH1 is different from the F-PDCCH0's.
In the F-PDCCH overlaid mode, the relative power of the F-PDCCH1
must be same as the F-PDCCH0's.
-221 Settings conflict; In the F-PDCCH overlaid mode, the slot positions of
the F-PDCCH1 cannot be overlapped with F-PDCCH0s'. Check the slot
position again.
In the F-PDCCH overlaid mode, the slot positions of the F-PDCCH1
cannot be overlapped with F-PDCCH0s'. Check the slot position
again.
-221 Settings conflict; In the F-PDCH0 and 1, the occupied number of walsh
codes at timeslot#{value} cannot exceed 28. Decrease the number of
walsh codes.
In the F-PDCH0 and 1, the occupied number of walsh codes must not
exceed 28. The number of walsh codes should be decreased.
-221 Settings conflict; Incompatible step sweep frequency setting. Start,
stop, center or span setting changed to be compatible with last
command.
Incompatible step sweep frequency setting. Start, stop, center or
span setting changed to be compatible with last command.
-221 Settings conflict; Incompatible step sweep power setting. Start, stop,
center or span setting changed to be compatible with last command.
Incompatible step sweep power setting. Start, stop, center or span
setting changed to be compatible with last command.
-221 Settings conflict; Increase in sweep span increases sweep time.
The minimum sweep time is dependant on the sweep span and start
freq.
-221 Settings conflict; Internal burst cannot be on with pulse modulation.
There is a hardware conflict between internal burst and pulse
modulation. The most recently requested modulation will be turned
on. The previous modulation will be turned off.
-221 Settings conflict; Invalid Channel Code on DPCH{value}. The channel
code has been changed from {value} to {value}
The Channel Code is limited by the Slot Format. Parameter 1 is
channel number, Parameter 2 and 3 are channelization codes.
-221 Settings conflict; Invalid Channel Code on OCNS{value}. The channel
code has been changed from {value} to {value}
The Channel Code is limited by the Symbol Rate. Parameter 1 is
channel number, Parameter 2 and 3 are channelization codes.
Page 29