User manual

lpErrorDoc.txt

format is off: {name}.

This error is reported when a file header command is tried when the

format is not on. File Headers can only be modified while the

format the file is associated with is turned on. {name} is a string

describing the Format.

-221 Settings conflict; The current data rate is not valid for this radio

configuration. Data rate changed to the default rate.

The new radio configuration does not support the current data rate.

The data rate is changed to the default rate for the new radio

configuration, which is 1X for F-FCH and 2X for F-SCH.

-221 Settings conflict; The current paging indicator (PI) is not valid for

2400 bps data rate. The PI has been changed to 0, the default.

QPCH channel with a data rate of 2400 bps only supports up to 191

paging indicators. The PI has been set to 0 (default value) to

remain valid for this data rate.

-221 Settings conflict; The current RC or data rate does not support turbo

coding. Turbo Coding has been turned off.

Either specification or hardware does not support turbo coding for

this data rate. Turbo coding is now turned off. If turbo coding is

desired, select a valid data rate and then turn turbo coding on.

For F-SCH channels, data rates below 14.4 kbps and the highest data

rates for each RC are not valid for turbo coding.

-221 Settings conflict; Data of DPDCH must not be TrCH when method of

active Compressed Mode is Higher Layer.

Transport channel coding is supported on compressed mode by SF/2,

but it is not supported on compressed mode by Higher Layer. Higher

Layer method supports physical channel coding only.

-221 Settings conflict; DCH data block is too large. Maximum size of Block

Set ( = Block Size * number of Blocks) is 200000. Reduce Block Size

or number of blocks.

The 3GPP standard defines the transport block set size as 0 to

200000

-221 Settings conflict; DCH generation is not support with a DPCH slot

format of 16.

DCH generation is not support with a DPCH slot format of 16.

-221 Settings conflict; The DCH which is referenced by 3GPP Uplink AWGN

must be on.

The DCH which is referenced by AWGN Eb Ref is off. To avoid this,

set the DCH to on.

-221 Settings conflict; Differential encoding has been turned off.

Differential encoding does not work above 50 Mbps.

-221 Settings conflict; The Digital Data state could not be turned on

because the module was not connected. Please connect the module before

turning the state on.

Page 24