User manual

lpErrorDoc.txt
The clipping function is not available for the CDMA2000 or 1xEV-DV
reverse link radio configurations 1 and 2. The value is
automatically reset to 100% (no clipping).
-221 Settings conflict; Clock Source Synchronized is only allowed when
Logic Type is LVDS and Data Direction is Input. Clock Source set to
Internal.
This error is reported when the Clock Source is set to Synchronized
and then the Logic Type is changed from LVDS or the Data Direction
is set to Output.
-221 Settings conflict; The command cannot be executed when no TDMA or Real
Time Custom mode is on.
The command (e.g. MEM:DATA:PRAM:BLOCK) can be executed only when a
TDMA mode (or Real Time Custom) is not on. Turn the desired mode on
and then resend the command.
-221 Settings conflict; Compressed Mode can't be activated when DPCCH state
is OFF.
DPCCH state shall be On when CM is Active.
-221 Settings conflict; Compressed Mode should be off when {name}.
Compressed Mode should be off when
any antenna is selected as Transmit Diversity
or OutOfSyncTest is on
or Transport Position is Flexible.
-221 Settings conflict; conflict between code = {value}, spread factor =
{value} and code = {value}, spread factor = {value}
A channelization code conflict exists between two codes, each at
its respective spread factor. Parameters 1 and 3 are channelization
codes. Parameters 2 and 4 are spread factors.
-221 Settings conflict; conflict between code = {value},data rate = {value}
sps and code = {value}, data rate = {value} sps
A channelization code conflict exists between two codes, each at
its respective data rate. Parameters 1 and 3 are channelization
codes. Parameters 2 and 4 are data rates.
-221 Settings conflict; Continuous and Discontinuous setting conflict. All
selected Continuous timeslots are now set to Discontinuous.
Indicates that while in TETRA mode an attempt has been made to
simultaneously assign continuous and discontinuous protocols to the
timeslots. Continuous and discontinuous protocols cannot coexist in
TETRA mode. If a discontinuous protocol is selected for any
timeslot, all timeslots' protocols are changed to discontinuous
protocols.
-221 Settings conflict; Continuous protocol timeslots cannot be turned off.
A continuous protocol timeslot is switched off while in TETRA mode.
When a continuous protocol has been selected for a timeslot in
TETRA mode, all of the timeslots must be switched on.
-221 Settings conflict; Could not perform File Header operation while
Page 23