User manual

lpErrorDoc.txt
-221 Settings conflict; Cannot turn AWGN on, option 403 is required for any
AWGN functionality
Option 403 (AWGN) is required to enable the AWGN portion of option
400 (WCDMA).
-221 Settings conflict; cannot update Baseband generator with Even Second
Delay.
There is an error with the CDMA2000 or 1xEV-DV hardware. Try
turning the CDMA2000 or 1xEV-DV mode off and on again to reset the
baseband generator card. If the problem persists, report this error
to Agilent Technologies.
-221 Settings conflict; Cannot use the Digital Bus while running over
100Msamples/sec. The Digital Bus has been turned off.
The Digital Bus cannot run over 100Msamples/sec. The Digital Bus
has been turned off.
-221 Settings conflict; Carrier formats must be the same.
All digital modulation multicarriers must be the same format.
-221 Settings conflict; Changing one of the setup parameters caused the
clock rate to be out of range. The clock rate has been clipped to its
new lower limit.
Clock rate limits are dependant on of the other setup parameters.
This error is reported when the parameters change causing the clock
rate to be below the new limits.
-221 Settings conflict; Changing one of the setup parameters caused the
clock rate to be out of range. The clock rate has been clipped to its
new upper limit.
Clock rate limits are dependant on of the other setup parameters.
This error is reported when the parameters change causing the clock
rate to be above the new limits.
-221 Settings conflict; Changing the sample rate has limited the baseband
frequency offset.
The absolute maximum baseband frequency offset is 4*sample_rate or
20MHz, whichever is smaller.
-221 Settings conflict; Channel #{value} must be on for any transport
channel following it to be on. All transport channels following
channel #{value} have been turned off
Transport channels must be turned on sequentially. Therefore, all
transport channels with a higher number than a channel that is
turned off will be automatically turned off.
-221 Settings conflict; Channel #{value} must be turned on before channel
#{value} can be turned on. Channel #{value} has been turned off.
Transport channels must be turned on sequentially. For example,
channels 1,2 and 3 must be turned on before channels 4 through 6
can be activated.
-221 Settings conflict; Clipping not allowed for CDMA2000 or 1xEV-DV
reverse radio configurations 1 and 2. Clipping set to 100%.
Page 22