User manual

lpErrorDoc.txt
turn the mode on. HSPA has been turned off.
To output a valid RF signal, at least one channel must be turned
on. Since all channels are off, HSPA mode has been turned off to
avoid undefined behavior.
-221 Settings conflict; At least one of the channels must be on in order to
turn the mode on. WCDMA has been turned off.
To output a valid RF signal, at least one channel must be turned
on. Since all channels are off, WCDMA mode has been turned off to
avoid undefined behavior.
-221 Settings conflict; At least one of the channels must be on in order to
turn the mode on. {name} has been turned off.
CDMA2000 or 1xEV-DV requires at least one channel to be on to turn
the mode on. Having at least one channel on in the current link
direction, and in the case of reverse link the current Operating
Mode, allows the mode to be turned on.
-221 Settings conflict; AUTO is not allowed for "SF and Number of E-DPDCHs"
if TFC E-TFC Pattern is not MAIN ALL.
AUTO is not allowed for "SF and Number of E-DPDCHs" if TFC E-TFC
Pattern is not MAIN ALL.
-221 Settings conflict; auto power search was aborted due to invalid
setting. Check the {name} parameters, then press APPLY to rerun auto
power search.
Auto power search is aborted for the reason described in error
message. Check the setting, then press APPLY to run Auto power
search.
-221 Settings conflict; BBG data clock has been set to internal. Ext data
bit clock does not work with combined GSM/EDGE.
Combined GSM/EDGE does not work with an external bit clock. However
it can be used with an external symbol clock.
-221 Settings conflict; BBG data clock has been set to internal. Ext data
bit clock does not work with data rates over 50 Mbps. Ext symbol clock
is okay.
Parallel mode does not work with an external bit clock. However it
can be used with an external symbol clock.
-221 Settings conflict; BCH Conflicts with another multiframe type.
*** No documentation ***
-221 Settings conflict; BCH is allowed only in TimeSlot 0.
*** No documentation ***
-221 Settings conflict; The bit rate has been set to 50 Mbps. Ext (serial)
data in and PRAM files do not work with data rates above 50 Mbps.
The bit rate has been set to 50 Mbps. Ext (serial) data in and PRAM
files do not work with data rates above 50 Mbps.
-221 Settings conflict; Block size has been adjusted to match BlockSetSize
Page 20