User manual

lpErrorDoc.txt
command.
-222 Data out of range; A burst rise shape must have at least two points.
Two points are needed to specify a rise shape in the MEM:DATA:SHAPe
command.
-222 Data out of range; A burst shape can only have up to {value} points
for the fall shape.
The user has specified more than the maximum number of points
allowed for the fall shape in the MEM:DATA:SHAPe command.
-222 Data out of range; A burst shape can only have up to {value} points
for the rise shape.
The user has specified more than the maximum number of points
allowed for the rise shape in the MEM:DATA:SHAPe command.
-222 Data out of range; A differential mapping can only have up to 256
states.
The user has specified more than 256 states in the MEM:DATA:IQ or
MEM:DATA:FSK commands for the differential states specification.
-222 Data out of range; A modulation must have at least two points.
Two points are needed to specify a 1 bit per symbol modulation.
This error can be reported for I/Q or FSK modulation specifications
using MEM:DATA:IQ and MEM:DATA:FSK.
-222 Data out of range; An FSK modulation can only have up to 16
frequencies.
The user has specified more than 16 frequencies in the MEM:DATA:FSK
command.
-222 Data out of range; An I/Q modulation can only have up to 256 states.
The user has specified more than 256 states in the MEM:DATA:IQ
command.
-222 Data out of range; Channel type not allowed for current link/config.
The channel type you are trying to add is not supported by the
current CDMA2000 or 1xEV-DV link and/or radio configuration.
-222 Data out of range; In the {name}, the slot position + num_slots cannot
exceed 64.
The slot position + number of time slots cannot exceed 64. The slot
position will be clipped.
-222 Data out of range; Manual point exceeds frequency list size. Limiting
to maximum point.
The sweep/list manual point has been reassigned to a smaller number
value due to the longest list decreasing in size or being turned
off. Its new value is the length of the frequency list that is the
longest enabled list.
-222 Data out of range; Manual point exceeds list sizes. Limiting to
maximum point.
Page 17