User manual

lpErrorDoc.txt
properly. Report this error to Agilent Technologies.
-230 Data corrupt or stale; Either the file is not a bit file, or the
number of bits specified does not match the number of data bytes in
the file.
An error has occurred while downloading a user file to the Bit
memory catalog. Either the user file is not a bit file, or the
number of bits specified in the SCPI command does not match the
number of bytes in the file. Ensure that the bit specifier matches
the actual number of bits in the file.
-230 Data corrupt or stale; File '{name}' Header Parameter Out of Range or
Not Valid: {name}.
This error is reported when trying to apply the header parameters
to the instrument state. If one of the parameters does not contain
a valid value for that state, this error is reported. The first {name}
is the file that generated the error. The second {name} will describe
which header field contained the invalid value.
-230 Data corrupt or stale; Header File is Not Found or Invalid: {name}.
This error occurs when trying to open a header file, the file does
not match any known header format or does not exist. {name} is the
filename being accessed.
-230 Data corrupt or stale; The user file version is not recognized. {name}
An error has occurred while loading a user file where the version
of the file is not recognized as a supported version.
-230 Data corrupt or stale; {name}
The sequence file that you are attempting to run is the wrong size.
-224 Illegal parameter value
Used where an exact value was expected from a list of
possibilities.
-224 Illegal parameter value; Analog bus node not present
The analog bus node that was selected is not a valid node in the
system.
-224 Illegal parameter value; Command requires at least one data value.
A modulation type cannot be created without data.
-224 Illegal parameter value; Illegal parallel bus address
Internal error. The instrument tried to access an illegal parallel
bus address.
-224 Illegal parameter value; Latch name not present
The latch name that was selected is not a valid latch in the
system.
-224 Illegal parameter value; Option 416 does not have a valid license.
*** No documentation ***
Page 14