User manual

lpErrorDoc.txt
-256 File name not found; {name} The burst shape type has been defaulted.
The specified file does not exist, so the burst shape type has been
defaulted.
-256 File name not found; {name} The filter type has been defaulted.
The specified file does not exist, so the filter type has been
defaulted.
-256 File name not found; {name} The modulation type has been defaulted.
The specified file does not exist, so the modulation type has been
defaulted.
-255 Directory full; {name}
A legal program command or query could not be executed because the
media directory was full.
-254 Media full; {name}
Invalid file or device name.
-253 Corrupt media; {name}
A source media (possibly EEPROM) for a data file is corrupt. This
error is usually seen in conjunction with errors concerning a
certain file.
-241 Hardware missing; Cannot access a baseband generator that does not
exist.
Tried to retrieve access information that was not created for a
given baseband generator. The hardware probably does not exist.
-241 Hardware missing; No Source Module connected
Cannot turn on Source Module Mode if source module is not
connected. Check cable connection.
-241 Hardware missing; SIO address does not exist
The expected board is not installed. Report this error to Agilent
Technologies.
-240 Hardware error
-233 Invalid version
A legal program data element was parsed but could not be
executed because the version of the data is incorrect to
the device. This particular error is used when file or block
data elements are recognized by the instrument, but cannot
be executed for reasons of version incompatibility. For
example, a non-supported file version or a non-supported
instrument version.
-230 Data corrupt or stale; EEPROM @ offset 0x%06X: wrote 0x%02hX, read
0x%02hX
After writing shadow RAM data to EEPROM, a memory comparison
detected a difference. The EEPROM may not be retaining data
Page 13