User`s guide

Index
301
Index
marker setting, saving 81
markers 111
trigger, external 114
port configuration, selecting 256
power
meter 135, 282
output, troubleshooting 280
peaks 117–123
receptacle, AC 28
search mode 283
supply troubleshooting 280
switch 14
PRAM 79
predefined filters 162
predefined modulation setups 159, 181
pre-fir samples selection 259, 271
Preset hardkey 14
private data 65
problems. See troubleshooting
product information 1
proprietary data 65
protecting data 65
PSG
additional information 1
firmware 6
modes of operation 7
options 6
web page 1
PSK modulation 171
pulse 130
annunciator 18
modulation 154
pulse modulation 4, 8, 46
simultaneous triggering 155
pulse performance, improving 283
pulse source 46, 154
PULSE SYNC OUT connector 33
PULSE VIDEO OUT connector 33
pulse width 283
pulse, marker, viewing 108
PULSE/TRIG GATE INPUT connector 33
Q
Q IN connector 34
Q Input connector 15
Q OUT connector
26
QAM modulation 171, 194
Q-bar OUT connector 27
QPSK I/Q modulation, creating 173
queue, error 289
R
R (remote) annunciator 18
ramp sweep 49–58
real time 79
real-time AWGN 237
real-time I/Q 181–200
real-time mode 8, 80
real-time noise 95
real-time triggers 111
rear panel description 20
Recall hardkey 10
recall state 55
recall states 63
receiver test 79
recovery sequence, fail-safe 288
rectangular clipping 124
reference
amplitude, setting 44
frequency, setting 43
GPS chip clock 213
MSGPS chip clock 209
oscillator bandwidth, adjusting 147
registers 63, 64
remote operation 139
remote operation annunciator 18
reset & run trigger response 113
response, triggering mode 112
restricted data 65
Return hardkey 14
returning a signal generator 291
RF blanking 279
marker function 109
settings, saving 98
RF On/Off hardkey 12
RF OUT connector 32
RF output
annunciator 18
configuring 42
connector 13