Technical data

Chapter 18 505
T1 Analyzer
Making T1 Measurements
T1 Analyzer
6 Setup monitoring.
a. [Monitor]
b. [Monitor Full T1]
Choose this to monitor performance of a full T1
Circuit.
7 Setup auto
configuration.
a. [Auto Config]
b. [Primary Auto
Config]
Causes the test set to analyze the incoming T1
signal and align the setup choices to that signal.
8 [Back] Shifts focus back to the main mode selection
buttons.
9 [Setup] Select this to display a list of setup choices that
pertain to this test mode.
10 Setup the Rx Input.
a. [Setup]
b. [Rx Input]
c. [Terminate]
This assumes the test set is connected into a jack
that interrupts the T1 circuit.
Note: If you are connected to a monitor port, select
[Monitor] instead of [Terminate].
11 Setup line code.
a. [Line Code]
b. [B8ZS]
This assumes the circuit is designed for B8ZS.
12 Setup framing.
a. [Framing]
b. [ESF]
This assumes that the circuit has been designed for
ESF.
Step Notes