User`s guide

11. Press Instrument Setup
(F1 key).
12. Scroll down and set the date in
yyyy.mm.dd format (example:
2002.11.5 = November 5, 2002).
If you set the correct date and
time here, then protocol logs
will include the correct date and
time. Press the knob and edit
the date, then press the knob to
set it.
13. Scroll down and set the time in
hh.mm 24-hour format
(example: 17.46 = 5:46 PM)
14. Press Close Menu (F6 key).
15. Press RF IN/OUT Amptd Offset
(F5 key).
16. Press RF IN/OUT Amptd Offset
Setup (F2 key).
Typically, it is alright to leave
the RF In/Out Amplitude Offset
State Value as “Off” for this
demo. If it is “On”, check that
reasonable values are entered in
the table for the phone’s RF test
cable.
17. Press Close Menu (F6 key).
18. Press the Call Setup key.
19. On the Call Parms (right)
column of softkeys, change Cell
Power (F7) to –50 dBm. For
Agilent demo phones (typically
a Motorola Timeport
®
), the test
set's default settings should
work fine:
Cell Band (F8): PGSM
Broadcast Chan (F9): 20
For other wireless appliances,
change the band and channel as
necessary.
20. On the Control (left) column of
softkeys, press the Data Conn
Type (F4) key.
21. Change the Data Conn Type to
IP Data.
22. On the Control column, press
the More key until you see
“2 of 2”.
23. Press the DUT PDP Setup key
(F2) and then press the knob.
This step sets the IP address
that the test set will assign to
the DUT, usually a GPRS phone.
24. Enter almost the same address
as the test set’s LAN IP address
except change the fourth set of
digits to an integer between 1
and 254. Enter it in the field
labeled “DUT IP Address”.
Example:
Test set's LAN IP address 111.222.33.4
Phone’s DUT IP address 111.222.33.5
IMPORTANT: The DUT IP address
and the test set's LAN IP address
cannot be the same. Do not set the
fourth set of numbers to 0 or to a
set of numbers greater than 254.
Additionally, the entered DUT IP
address must be on the same subnet
as the test set. (The test set’s Subnet
Mask was recorded on step 9 in
section 2.2.2)
25. After the IP address is entered,
press the knob.
26. Record the DUT IP address that
you entered:
27. Press the Close Menu (F6) key.
7