User`s guide

2.2 Setup
Using a PC connected directly to a
test set via a crossover LAN cable
allows experimentation with all of
the features of the Agilent E6701A
product (but does not provide
wireless appliance access to real
Internet Web sites via the test set).
Before you can perform this demon-
stration, you must configure the PC
LAN, PC software, phone, and test
set. For best results, perform the
procedures in this exercise in the
sequence outlined below.
If you want to demonstrate IP data
connections, you must have a WAP
gateway installed on your PC. To do
this, go to Appendix A: Installing a
WAP Gateway into a PC.
2.2.1 Equipment configuration
Connect cables as shown in Figure 1.
If a LAN jumper cable already is
connected on the rear panel of the
test set, disconnect it.
5
DUT
RF Test
Port
Device Under Test
(with Test SIM card installed)
RF IN/OUT
(Front Panel)
LAN PORT
(Rear panel)
Personal computer
(with Internet Explorer 5
web browser and WAP
gateway software installed)
Crossover LAN Cable
LAN
Port
RF Test Cable
E5515B/C
Test Set with
E6701A LA
Figure 1. A PC connected directly to a test set via a LAN crossover cable