User`s guide
33
3.6.3 Browsing “real” Web sites via
the WAPLite gateway with the
phone
1. The phone’s display should
show the Browser Menu. If the
phone’s Browser Menu is not
displayed, press the phone’s
Menu key briefly.
2. When the display shows
“Access Internet / Select?”,
press the OK key to select.
3. Hold down the Menu key for
about three seconds and
release.
4. On the Browser Menu, scroll to
2>Web Favorites with the
up/down arrow key.
5. Press OK.
6. Scroll to one of the web
addresses, or enter a
WAP-enabled website address.
Example:
http://thefunniest.com
http://wap.weatheronline.co.uk/wap/
city?en72785
http://wap.yospace.com
http://ayg.com.
7. Press OK key to Go. (The
phone requests data from the
website).
3.6.4 Logging IP datagrams while
accessing a Web site with the
phone
It is interesting to note that during
a log of IP datagram transfers, the
LAN cable will carry IP datagrams
between the phone and the WAP
gateway software running on the
PC. Simultaneously, the same LAN
cable will carry the protocol logging
data between the test set and the
Internet Explorer software running
on the PC.
To demonstrate this, follow the pro-
cedures below:
1. On the PC, go back to the active
Internet Explorer browser with
the 8960 Web control page.
2. Select Logging Setup to change
the observation points.
3. Select IP (only) and OK.
4. Select the Start Logging icon.
5. On the phone, on the Browser
Menu, scroll to 2>Web
Favorites with the up/down
arrow key.
6. Press OK key.
7. Scroll to one of the Web site
addresses.
8. Press OK key to Go. (The
phone requests data from the
device at the selected address).
Watch the test set display; the
active cell window will switch
between “PDP Active” and
“Transferring” as IP datagrams
are sent back and forth from
the phone to the WAPLite
server on the PC to the
Internet.
9. Select the Stop Logging icon
and examine the log data on
the PC.
3.6.5 Disabling WAPLite software
When you complete your WAP
demonstration, disable the WAPLite
software to give you the maximum
trial usage period.
1. In the WAPLite window, select
the Stats tab to turn off the
WAP Gateway software in your
PC.
2. Click on Remove Service.
3. When it asks “Are you sure?”,
select Yes and wait a few
moments until the software
shuts down and indicates
“Active Time: Not Active”.
4. Click OK to exit the program.