User`s guide

3.4.1 Buffer operation
1. Select Linear. The Linear buffer
stops the log when the logging
memory location is full. The
Cyclic buffer writes over the
oldest data once it is full.
2. Scroll to the bottom of the page.
3. Enter a user comment if desired
to annotate the log. This can be
up to 74 characters in length
and must be alphanumeric
characters only.
4. Select OK to save the setup and
return to the main logging page.
5. Select the Start Logging icon.
6. Turn on power to the phone to
perform a switch-on and attach.
The phone should indicate
service signal-strength bars in
the upper-left corner of the
display within about one
minute. It should also indicate
the numbers “001-01” or the
word “Test” in the center of the
display, which is the default test
network number stored in the
test set. On the test set, in the
bottom center of the display, the
active cell box should show
“Attached”.
7. Select the Stop Logging icon.
Note that no data will be
displayed until the log is
stopped. The test set has
captured the log data in its
internal memory.
3.4.2 Examining the log data on the PC
1. Look in the PC’s upper window
using the scroll bar to see the
Message Summary. If you
click on one of the message
summaries, a hyperlink will
launch in the lower window to
show you the detail for that
message.
2. Look in the lower window using
the scroll bar to see the Message
Details. Notice the time stamp
and message number at the
front of each message.
Refer to the E6701A Lab
Application User’s Guide for
more details on logged
messages.
3.4.3 Saving the log data
To save this log data in the PC,
follow these steps.
1. At the top left corner of the
Internet Explorer window,
select File, then Save As.
2. On the Save Web Page window,
choose a directory.
To more easily find your log
files, select the Create New
Folder icon.
3. For this demonstration, name
your New Folder: “E6701A
Demo Logs” then press the
Enter key. Double-click your
new folder. “E6701A Demo
Logs” is shown in the Save in
box above.
4. In the File name box, enter a
different name for this log. For
this demo, use “Good Stuff1”.
(Note: You must highlight the
entire default filename to
replace it).
5. Leave Save as type: box at
default—Web Page, complete
(*.htm, *.html)
6. Leave Encoding: box at default –
Western European (ISO)
7. Select the Save button.
27