User`s guide

3.2.6 Verify PC settings
1. On the PC, start Microsoft
Internet Explorer software. If
you get a message saying “Work
Offline” or “Try Again”, choose
the Try Again box. If applicable,
allow the PC to access its
normal homepage.
2. On the PC, enter the LAN IP
address of the test set (recorded
in section 3.2.1); then press
Enter. If you get a message
saying “Work Offline” or “Try
Again”, choose the Try Again
box. The 8960 web page should
display.
3.2.7 Verify GPRS attach function
1. If necessary, follow the
manufacturer’s instructions to
install the test SIM into the
phone or wireless appliance.
2. Turn on the phone or wireless
appliance.
• The phone should indicate
service signal-strength bars
(in the upper left corner of
the display) within about one
minute.
• It also should indicate the
numbers “001-01” or the word
“Test” in the center of the
display. This is the default
test network number stored
in the test set.
• On the test set, in the bottom
center of the display, the
active cell box should show
“Attached”. If it does, skip to
section 3.2.8.
3. If the phone does not show
service, check the phone for a
label indicating a different Cell
Band or Broadcast Channel,
and enter those into the test set.
4. Check that the phone’s band
matches the test set's Cell Band.
a. For the Motorola Timeport
phone, press the phone’s
Menu key briefly.
b. Scroll to Network Selection
with the up/down arrow key.
c. Press OK key to “View
Options?”.
d. The phone should display
“Change Band”.
e. Press OK key to “View
Options?”. Scroll to “Change
to 900/1800”. Press OK key to
Select?.
f. If the phone still doesn’t
show service, look in
Appendix B: Troubleshooting.
24