User`s guide

3.2 Setup
Before you can perform this demon-
stration, you must configure the PC
LAN, PC software, phone, and the
test set. This is done using the
following procedures. If you adjust
IP addresses for the demonstration,
remember to set them back to the
original settings when the demo is
finished so that the devices will
work on their normal networks. If
you want to demonstrate Internet
Web browsing with IP data connec-
tions, you must have a WAP gateway
installed on your PC. To do this,
refer to Appendix A.
3.2.1 Required addresses
Before you can do this demonstra-
tion, contact your Network
Administrator. Many LANs use a
combination of static (fixed) and
dynamic DHCP (variable) IP
addresses while others use only
static IP addresses.
If your network uses only static
addresses, ask for three static IP
addresses to use during your
demonstration, as well as the subnet
mask and gateway. Record the
address information in the spaces
provided to the right.
If your network uses static and
dynamic addresses, ask for two stat-
ic IP addresses for use during your
demonstration, as well as the subnet
mask and gateway. Record the
address information below.
IP address #1
(for the test set’s LAN address):
_________________________________
IP address #2
(for the DUT IP address):
_________________________________
IP address #3
(for the PC's LAN address if static):
_________________________________
Network Subnet Mask:
_________________________________
Network Gateway:
_________________________________
18